Injector Test

Introduction:

-The tester generating four different output signal

    pulses for user to check the condition of the injector.

-Can check if the injector is clogged, leaking, or blasting.

Specification:

-Input power: 12V vehicle battery.

-Working Environment: 0~40℃ (32~104℉); < 80%RH

-Storage Environment: -10~50℃ (14~122℉); < 85%RH

 Description:

1.) Black battery clip (connecting with negative pole of the battery)

2.) Red battery clop (connecting with negative pole of the battery)

3.) Output signal connector (connecting with the injector)

4.) Mode indicator

5.) Pules indicator

6.) Pules switch

7.) Mode setting switch

Operation:

1.) Switch off the engine, connect the black battery

      clip to the negative of the car Battery, and the

      red battery clop to the positive of the car battery.

2.) Disconnecting the injector with connector from

      vehicle then connecting the “Output signal connector”

      with the injector.

3.) Press “mode setting switch” to select the output

      signal pulse mode; there are 4 modes of the pulse:

Mode 1: Press “PULSE” switch to generate 1 pulse;

          the width of the pulse is 250ms

Mode 2: Press “PULSE” switch to generate 50 pulses;

          the width of the pulse is 8ms

Mode 3: Press “PULSE” switch to generate 100 pulses;

          the width of the pulse is 4ms

Mode 4: Press “PULSE” switch to generate 50 pulses

          every 1500ms continuously; the width of the

          pulse is 8ms. Press “PULSE” switch again will

          stop the signal.

4.) After selecting the pulse mode, press the witch

      “PULSE” to generate the pulse. The “Pulse indicator”

      will light up as the signal id generating.

Packing: Color Box