Introduction:
-The tester generating four different output signal
pulses for user to check the condition of the injector.
-Can check if the injector is clogged, leaking, or blasting.
Specification:
-Input power: 12V vehicle battery.
-Working Environment: 0~40℃ (32~104℉); < 80%RH
-Storage Environment: -10~50℃ (14~122℉); < 85%RH
Description:
1.) Black battery clip (connecting with negative pole of the battery)
2.) Red battery clop (connecting with negative pole of the battery)
3.) Output signal connector (connecting with the injector)
4.) Mode indicator
5.) Pules indicator
6.) Pules switch
7.) Mode setting switch
Operation:
1.) Switch off the engine, connect the black battery
clip to the negative of the car Battery, and the
red battery clop to the positive of the car battery.
2.) Disconnecting the injector with connector from
vehicle then connecting the “Output signal connector”
with the injector.
3.) Press “mode setting switch” to select the output
signal pulse mode; there are 4 modes of the pulse:
Mode 1: Press “PULSE” switch to generate 1 pulse;
the width of the pulse is 250ms
Mode 2: Press “PULSE” switch to generate 50 pulses;
the width of the pulse is 8ms
Mode 3: Press “PULSE” switch to generate 100 pulses;
the width of the pulse is 4ms
Mode 4: Press “PULSE” switch to generate 50 pulses
every 1500ms continuously; the width of the
pulse is 8ms. Press “PULSE” switch again will
stop the signal.
4.) After selecting the pulse mode, press the witch
“PULSE” to generate the pulse. The “Pulse indicator”
will light up as the signal id generating.
Packing: Color Box